GS108T and GS110TP Smart Switch Software Administration Manual
Maintenance 7-11
v1.0, April 2010
4. To remove the selected image from permanent storage on the switch, select the Delete Image
check box. You cannot delete the active image.
5. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest
value of the switch.
6. Click Apply to apply the settings to the switch.
Dual Image Status
You can use the Dual Image Status page to view information about the system images on the
device.
To display the Dual Image Status page, click Maintenance File Management Dual Image
Dual Image Status.
Note: After activating an image, you must perform a system reset of the switch in
order to run the new code.
Figure 7-7
To Next Page
Loading...
