NETGEAR GS108T-200NAS - Configuring the Network Settings on the Administrative System

GS108T and GS110TP Smart Switch Software Administration Manual
Getting Started 1-7
v1.0, April 2010
Configuring the Network Settings on the Administrative
System
If you choose not to use the Smart Control Center to configure the network information on the
switch, you can connect directly to the switch from an administrative system, such as a PC or
laptop computer. The IP address of the administrative system must be in the same subnet as the
default IP address on the switch. For most networks, this means you must change the IP address of
the administrative system to be on the same subnet as the default IP address of the switch
(192.168.0.239).
To change the IP address on an administrative system running a Microsoft
®
Windows
®
operating
system, open the Internet Protocol (TCP/IP) properties screen that you access from the Local Area
Connection properties, as shown in Figure 1-5. You need Windows Administrator privileges to
change these settings.
Figure 1-5