GS108T and GS110TP Smart Switch Software Administration Manual
1-6 Getting Started
v1.0, April 2010
6. Select the switch, then click Configure Device. The page expands to display additional fields
at the bottom of the page, as Figure 1-4 shows.
7. Choose the Disabled radio box to disable DHCP.
8. Enter the static switch IP address, gateway IP address and subnet mask, and then type your
password and click Apply.
Please ensure that your PC and the switch are in the same subnet. Make a note of these settings for
later use.
Figure 1-4
Note: You must enter the current password every time you use the Smart Control
Center to update the switch setting. The default password is password.
To Next Page
Loading...
