GS108T and GS110TP Smart Switch Software Administration Manual
5-8 Managing Device Security
v1.0, April 2010
To configure the RADIUS accounting server:
1. In the Accounting Server Address field, specify the IP address of the RADIUS accounting
server to add.
2. In the Port field, specify the UDP port number the server uses to verify the RADIUS
accounting server authentication. The valid range is 0–65535.
3. From the Secret Configured menu, select Yes to add a RADIUS secret in the next field. You
must select Yes before you can configure the RADIUS secret. After you add the RADIUS
accounting server, this field indicates whether the shared secret for this server has been
configured.
4. In the Secret field, type the shared secret to use with the specified accounting server.
5. From the Accounting Mode menu, enable or disable the RADIUS accounting mode.
6. Click Apply to update the switch with the RADIUS Accounting server settings.
Figure 5-4
To Next Page
Loading...
