GS108T and GS110TP Smart Switch Software Administration Manual
Managing Device Security 5-33
v1.0, April 2010
To configure MAC filter settings:
1. To configure a new MAC filter:
a. Select Create Filter from the MAC Filter menu. If no filters have been configured, this is
the only option available.
b. From the VLAN ID menu, select the VLAN to use with the MAC address to fully identify
packets you want filtered. You can change this field only when the Create Filter option is
selected from the MAC Filter menu.
c. In the MAC Address field, specify the MAC address of the filter in the format
00:01:1A:B2:53:4D. You can change this field when you have selected the Create Filter
option.
You cannot define filters for the following MAC addresses:
• 00:00:00:00:00:00
• 01:80:C2:00:00:00 to 01:80:C2:00:00:0F
• 01:80:C2:00:00:20 to 01:80:C2:00:00:21
• FF:FF:FF:FF:FF:FF
d. Click the orange bar to display the available ports and select the port(s) to include in the
inbound filter. If a packet with the MAC address and VLAN ID you specify is received on
a port that is not in the list, it will be dropped.
Figure 5-18
To Next Page
Loading...
