GS108T and GS110TP Smart Switch Software Administration Manual
5-36 Managing Device Security
v1.0, April 2010
To configure storm control settings:
1. Select the check box next to the port to configure. Select multiple check boxes to apply the
same setting to all selected ports. Select the check box in the heading row to apply the same
settings to all ports.
2. From the Ingress Control Mode menu, select the mode of broadcast affected by storm control.
• Disable. Do not use storm control.
• Unknown Unicast. If the rate of unknown L2 unicast (destination lookup failure) traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped.
Figure 5-20
To Next Page
Loading...
