GS108T and GS110TP Smart Switch Software Administration Manual
Configuring System Information 2-47
v1.0, April 2010
To configure DHCP filtering settings for an interface:
1. To configure DHCP filtering settings for a physical port, click PORTS.
2. To configure DHCP filtering settings for a Link Aggregation Group (LAG), click LAGS.
3. To configure DHCP filtering settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the heading
row to apply the same settings to all interfaces.
5. Choose the trust mode for the selected port(s) or LAG(s).
• Enable: Any DHCP responses received on this port are forwarded.
• Disable: Any DHCP (or BootP) responses received on this port are discarded.
6. Click Apply to apply the change to the system. Configuration changes take effect
immediately.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
Figure 2-27
To Next Page
Loading...
