GS108T and GS110TP Smart Switch Software Administration Manual
Configuring Switching Information 3-13
v1.0, April 2010
To configure VLAN membership:
1. From the VLAN ID field, select the VLAN to which you want to add ports.
2. Click the orange bar below the VLAN Type field to display the physical ports on the switch.
3. Click the lower orange bar to display the LAGs on the switch.
4. To select the port(s) or LAG(s) to add to the VLAN, click the square below each port or LAG.
You can add each interface as a tagged (T) or untagged (U) VLAN member.
• Tagged: Frames transmitted from this port are tagged with the port VLAN ID.
• Untagged: Frames transmitted from this port are untagged. Each port can be an untagged
member of only one VLAN. By default, all ports are an untagged member of VLAN 1.
In the following figure, ports g6, g7, and g8 are being added as tagged members to VLAN 2.
Figure 3-9
Figure 3-10
To Next Page
Loading...
