NETGEAR GS908E - Set an Existing 802.1 Q-Based VLAN as the Voice VLAN and Adjust the Cos Value

7. Click the icon for a port.
The PVID menu displays.
8. From the PVID menu, select a VLAN ID and name.
9. Click the APPLY button.
Your settings are saved. The Port and VLAN IDs section displays again.The VLAN ID that is assigned
as the PVID displays with an asterisk (*) next to the port.
10. Click the BACK button.
The VLAN page displays.
Set an Existing 802.1Q-Based VLAN as the Voice VLAN and
Adjust the CoS Value
The switch can support a single 802.1Q-based voice VLAN to facilitate voice over IP (VoIP) traffic.
The default Class of Service (CoS) value for the voice VLAN is 6, which you can adjust to any value from
0 (the lowest priority) to 7 (the highest priority). The voice VLAN CoS value applies to all traffic on the voice
VLAN.You can set the default VLAN (VLAN 1) as the voice VLAN.
To set an existing 802.1Q-based VLAN as the voice VLAN and adjust the CoS value for the
voice VLAN:
1. Open a web browser from a computer that is connected to the same network as the switch or to the
switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4. From the menu at the top of the page, select SWITCHING.
The Quality of Service (QoS) page displays.
5. From the menu on the left, select VLAN.
The VLAN page displays.
If you did not yet activate the 802.1Q-based VLAN mode, see Activate the 802.1Q-Based VLAN Mode
on page 40.
6. In the 802.1Q-based VLAN section, click the down arrow for the VLAN that you want to set as the voice
VLAN.
7. Click the EDIT button.
8. Under the Port section, click the Voice VLAN button.
If the voice VLAN is enabled, the button displays blue.
9. From the Class of Service menu, select a CoS value.
Use VLANS for Traffic Segmentation
45
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS908E