NETGEAR ProSafe WNAP320

Appendix B. Command-Line Reference | 115
ProSafe Wireless-N Access Point WNAP320 Reference Manual
| |
| |-radius>
| | |-accounting-server-primary --primary accounting server
| | |-accounting-server-primary-port --primary accounting server port
| | |-accounting-server-primary-sharedsecret --primary accounting server shared secret
| | |-accounting-server-secondary --secondary accounting server
| | |-accounting-server-secondary-port --secondary accounting
server port
| | |-accounting-server-secondary-sharedsecret --secondary accounting server shared secret
| | |-authentication-server-primary --primary authentication server
| | |-authentication-server-primary-port --primary system accounting server sh.secret
| | |-authentication-server-primary-sharedsecret --primary authentication server shared secret
| | |-authentication-server-secondary --secondary authentication server
| | |-authentication-server-secondary-port --secondary authentication server
port
| | |-authentication-server-secondary-sharedsecret --secondary authentication server sh.secret
| |
| |-remote> --enable remote access via SSH
| | |-ssh-port --SSH port
| | |-sshd
--SSH daemon
| | |-telnet --enable remote access via Telnet
| |
| |-snmp> --SNMP setting
| | |-description --SNMP system description
| | |-read-community --SNMP ReadCommunity
| | |-snmp-status
--SNMP status
| | |-trap-community --SNMP ReadCommunity
| | |-trap-server --SNMP TrapServer IP address
| | |-write-community --SNMP
WriteCommunity
| |
| |-spanning-tree --enable spanning tree protocol
| |-time>
--time Setting
| | |-custom-ntp-server --custom NTP server host name
| | |-daylightsaving --daylight saving
| | |-ntp-client --NTP client host name
| | |-ntp-server
--NTP server host name
| | |-time-zone --time zone
| |
| |-vlan> --vlan settings
| | |-management-vlan --vlan management id
| | |-untagged-vlan --untagged vlan id
| | |-untagged-vlan-status --untagged vlan status
|
|
|
|-exit --logout from CLI
|-file --
|-firmware-upgrade
--upload new system firmware file
|-password --system password
|-restore-configuration --restore system configuration