NETGEAR ProSafe WNAP320 User Manual

98 | Chapter 6. Troubleshooting
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Basic Functioning
After you turn on power to the wireless access point, check that the following sequence
of events occurs:
• Th
e Power/Test LED is first steady amber, then goes off, and then blinks green before
turning steady green after about 45 seconds.
• Th
e Active LED is lit or blinks green when there is Ethernet traffic.
• Th
e LAN LED indicates the LAN speed: green for 1000 Mbps, amber for 100 Mbps, and
no light for 10 Mbps.
• Th
e WLAN LED is lit or blinks green when the wireless LAN (WLAN) is ready.
If any of these conditions does not occur, see to the appropriate following section.
No LEDs Are Lit on the Wireless Access Point
It takes a few seconds for the power LED to light up. Wait a minute and check the Power LED
status on the wireless access point. If the wireless access point has no power:
If you use a PoE switch to provide power to the wireless access point, check these
items
:
• Make sure
that the Ethernet cable between the wireless access point and the PoE switch
is correctly connected at both ends.
• Ma
ke sure that the power cord of the PoE switch is plugged into a working power outlet or
power strip.
• Make
sure that your PoE switch is functioning normally.
If you use a power cord to provide power to the wireless access point, check these
items
:
• Make
sure that the power cord is connected to the wireless access point.
• Make
sure that the power adapter is connected to a functioning power outlet. If it is in a
power strip, make sure that the power strip is turned on. If it is plugged directly into the
wall, verify that it is not a switched outlet.
• Make
sure that you are using the correct NETGEAR power adapter that is supplied with
your wireless access point.

NETGEAR ProSafe WNAP320 Specifications

General

Brand	NETGEAR
Model	ProSafe WNAP320
Category	Wireless Access Point
Language	English