Chapter 2. Installation and Basic Configuration | 21
ProSafe Wireless-N Access Point WNAP320 Reference Manual
3. Click Apply to save your settings.
Configure IP Settings and Optional DHCP Server Settings
To configure the IP settings:
1. Select Con
figuration > IP > IP Settings. The IP Settings screen displays:
Figure 10.
2. Specify the fields as explained in the following table:
Use Custom NTP Server Select this check box to If you want to use a custom NTP server.
Note: You must have an Internet connection to use an NTP server that is not
on you
r local network.
Hostname /
IP Address
Enter the host name or IP address of the custom NTP server.
The default is time-b.netgear.com.
Table 4. IP Settings
Field Description
DHCP Client By default, the Dynamic Host Con
figuration Protocol (DHCP) client is disabled. If
you have a DHCP server on your LAN and you select the Enable check box, the
wireless access point will receive its IP address, subnet mask, and default
gateway settings automatically from the DHCP server on your network when you
connect the wireless access point to your LAN.
IP Address Enter the IP address of your wireless access poi
nt. The default IP address is
192.168.0.100. To change the address, enter an unused IP address from the
address range used on your LAN, or enable DHCP the server.
Table 3. Time System Settings (Continued)
Field Description
To Next Page
Loading...
Need help?
General
