NETGEAR ProSafe WNAP320

Chapter 5. Advanced Configuration | 93
ProSafe Wireless-N Access Point WNAP320 Reference Manual
To configure the wireless access point as a wireless repeater:
1. Con
figure the security profiles on the wireless access point (AP2 in the previous figure):
a. Select Co
nfiguration > Wireless Bridge. The Bridging screen displays:
Figure 58.
b. Select the Enable Wireless Bridging check box. The Local MAC Address field is a
nonconfigurable field that shows the MAC address of the wireless access point.
c. Select
the Wireless Point-to-Multi-Point Bridge radio button.
d. T
he profile table shows four security profiles. Choose a security profile to edit by
selecting the corresponding radio button to the left of the profile.
e. Click Edit to con
figure the selected security profile settings. The Edit Security Profile
screen displays for the selected security profile. (The following figure contains some
examples.)
Figure 59.