Connect to the router network
You can connect to the router network using a wired or WiFi connection.
Note: If you set up your computer to use a static IP address, change the settings so
that it uses Dynamic Host Configuration Protocol (DHCP).
Connect to the router WiFi network
You can connect a WiFi-enabled computer or mobile device to the router WiFi network
using the router WiFi network name (SSID) and WiFi password (network key)
To connect to the WiFi network:
1. Make sure that the router is receiving power (its Power LED is lit).
2. On your computer or mobile device, open your WiFi network management
application.
This is the application that lets you manage your WiFi connections.
3. Find and select the router WiFi network name (SSID).
The router WiFi network name (SSID) is on the router label.
4. Enter the router WiFi password.
The router WiFi password is on the router label. The WiFi password is also known
as the network key or passphrase.
Your computer or mobile device connects to the WiFi network.
Connect to the router using a wired connection
You can connect your computer to the router using an Ethernet cable and join the
router’s local area network (LAN). After setup, you can also connect other wired devices.
To connect your computer or other device to the router with an Ethernet cable:
1. Make sure that the router is receiving power (its Power LED is lit).
2. Connect an Ethernet cable to an Ethernet port on your computer.
If your computer doesn’t have an Ethernet port, you might be able to connect a USB
to Ethernet adapter to a USB port on your computer, and then connect the Ethernet
cable to the adapter’s port.
3.
Connect the other end of the Ethernet cable to an Ethernet port on the router.
Your computer connects to the local area network (LAN).
User Manual16Connect to the Router Network
and Access the Router
4-Stream AX1600 WiFi 6 Router Model RAX5
To Next Page
Loading...
Need help?
General
