HX4E/MX8A Series Voice Gateway User Manual
New Rock Technologies, Inc. 55
The following modes are available.
Power on: the gateway detects whether there are configurations and firmware to be
updated when the device is powered on.
Power on + Periodical: when the device is powered on, the gateway first checks
whether there are configurations and firmware to be updated, and then periodically
performs checking based on the set times.
When Power on+Periodical is set, this parameter specifies the interval for periodic
automatic upgrades. The default is 3600 seconds.
2.7.3 Management System Type
After login, click the label of Advanced > System to open this interface.
Figure 2-29 SNMP configuration interface
Table 2-23 SNMP Configuration Parameters
Enter the SNMP local port. The default value is 2700.
If SNMP is selected, the following three parameters need to be specified.
Enter the address of the SNMP server.
Enter the port number of the SNMP server. The default value is 162.
The default value is 900 seconds. The default value is 900 seconds.