Newport 2832-C - Model 2832-C Remote Interface Commands

Section 5
Command Reference
Model 283X Remote Interface Commands
The Model 2832-C remote commands can be divided into two groupings:
i.
Device lndependent Commands, Section 5.2
ii. Device Dependent Commands, Section 5.3
Table 21 lists the Device lndependent Commands supported by the 28324
while Table 22 lists the Device Dependent Commands supported the 2832-C.
Following these tables are the detailed presentations of each command and its
syntax and an example of its use.
Table 21 - Device lndependent Stalus Commands
Command Command Name
*CAL?
*CLS
ERR?
*ESE
*BE?
*ESR?
*IDN?
IST?
*OPC
*OPC?
*PRE
*PRE?
*RCL
*RsT
*SAV
*SRE
*SRE?
*STB?
*TST?
*WAl
Calibration Query
Clear Status
Error Query
Event Status Enable
Event Status Enable Query
Event Status Register Query
Identification Query
lndividual Status Query
Signal When Operation Complete
Operation Complete Query
Parallel Poll Enable
Parallel Poll Enable Query
Recall Device Configuration
Software Reset
Save Device Configuration
Service Request Enable
Service Request Enable Query
Status Byte
System Test
Wait To Continue
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com