Device Dependent Commands
AITN-n
Attenuator Calibration Data Enable
Syntax:
A-N-n <state>
where n
is
either A or B
Parameters:
The parameter <state>
is
either
0
or
1.
If
<state>
is
0,
then detector
responsivity data is used to calculate readings.
It
<state> is
1,
then the detec-
tor
+
attenuator responsivity data is used to calculate readings.
Function:
This command enables or disables the use of attenuator responsivity data
when user calibration
is
disabled.
If
enabled, responsivity data collected with
the attenuator attached to the detector
is
used in data calculations.
If
dis-
abled, responsivity data collected with the detector alone is used in data
calculations.
This command will generate
an
error if the attached detector does not sup
port an attenuator.
Related
Commands:
A'ITN-n?, A'ITNSN-n?, LAMBDA-n,
ATIN-n?
Attenuator Calibration Data Enable Query
Syntax:
A-N-n?
where n
is
either A or B
Parameters:
None
Function:
This query returns a value showing whether or not attenuator responsivity
data will be used when user calibration
is
disabled.
Returns:
<state>
<state>
is
of type <number> which represents the integer
0
if
detector
responsivity data
is
being used or
1
if detector
+
attenuator responsivity data
is
being used.
Related Commands:
A'ITN-n, A'ITNSN-n?, LAMBDA-n, LAMBDA-n?,
RESP-n?, USRCAL-n, USRCAL-n?, USRRESP-n, USRRESP-n?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
