LBP2 User Guide Document No: 50306-001 Rev G 3/12/2020 Page 44
2.6.3.4 Hide
To remove a results item from the Results display, place your mouse on the
title of the results item and click on the Hide icon that appears next to it.
Observe that if the result item has been Dragged and Dropped in another
window, hiding it in the results window does not remove it from that window.
That removal must be performed separately.
2.7 Aperture Ribbon and Controls
LBP2 can display three types of apertures: a manually drawn, an Auto Aperture, and a
Beam Width aperture.
The Manual and Auto Aperture limit the region where data is analyzed and the
results computed.
The Beam Width aperture is a display device that indicates the size and approximate
location and orientation of the computed beam widths. The assigned Beam Width
Basis is used to define the size of this aperture.
2.7.1 Manual Aperture
The Manual Aperture (displayed in Lt Grey) can be drawn in one of four user
selectable shapes: Circle, Ellipse, Square, or Rectangle. The aperture size,
position, and orientation can be controlled by entering numerical values in the
above edit boxes, or it can be manipulated by the mouse.
To manipulate the aperture begin by clicking somewhere on its perimeter. This
will open a set of handles that provide grab point for moving, sizing and
reorientation.
To Next Page
Loading...
Need help?
General
