Nexcom NISE 104 - Chapter 3: System Setup; Removing the Chassis Cover; Installing the DDR3 SODIMM

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
30
NISE 104 User Manual
Chapter 3: System Setup
ChaPter 3: system setuP
1.With the bottom side of the chassis facing up, remove the mounting screws
of the bottom cover and then put them in a safe place for later use.
1.Locate the SODIMM socket on the board.
2.Lift up the cover and remove it from the chassis.
DDR3 SODIMM Socket
Removing the Chassis Cover Installing the DDR3 SODIMM
CAUTION!
CAUTION!CAUTION!
Prior to removing the chassis cover, make sure the unit’s power is
off and disconnected from the power sources to prevent electric
shock or system damage.