Setup Tools
5.10 Software Versions
The software versions screen reports the version of each software component in the
starter:
• user interface
• motor control
• remote keypad (if connected)
• parameter list
• bootloader
• expansion card (if fitted)
NOTE
Updated software, including alternative languages, can be loaded into the starter
via the USB port if required. Contact your local supplier for further information.
5.11 Thermistor Reset
The thermistor input is disabled by default, but activates automatically when a thermistor is
detected. If thermistors have previously been connected to the soft starter but are no longer
required, use the Thermistor Reset function to disable the thermistor.
5.12 Reset Thermal Model
The soft starter's thermal modelling software constantly monitors the motor's performance.
This allows the starter to calculate the motor's temperature and ability to start successfully
at any time.
The thermal model can be reset if required.
CAUTION
Resetting the motor thermal model will compromise thermal model protection and
may compromise motor life. Only reset the thermal model in an emergency.
31
To Next Page
Loading...
Need help?
General
