Nidec Digistart D4 - Page 54

Programmable Parameters
6I – Network Communications
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Stop
Trip and Reset
Trip + Shunt Relay
Description: Selects the soft starter's response to the protection event. If set to Stop, the
soft starter will perform a soft stop, then can be restarted without a reset.
6J – Remote Keypad Fault
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description: Selects the soft starter's response to the protection event.
6K – Frequency
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description: Selects the soft starter's response to the protection event.
6L – Phase Sequence
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description: Selects the soft starter's response to the protection event.
6M – Motor Overtemperature
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description: Selects the soft starter's response to the protection event.
6N – Motor Thermistor Circuit
Options:
Soft Trip and Log (default) Warn and Log
Soft Trip and Reset Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description: Selects the soft starter's response to the protection event.
52