Choose start point and Choose end point. Your movie
must be at least 2 seconds long when you’re done or the
camera will refuse to cut any more frames, giving you
the terse message Cannot edit movie.
My Recommendation: I think this process is slightly easier
when executed from the Playback Retouch Menu. Try doing
the above steps by bringing up the movie on the Monitor,
pressing the OK button, and then following steps 1-6. The
reason it’s easier is that the Playback Retouch Menu presents
fewer steps. When you cut the front end off the movie, it
appears on-screen so that you can immediately cut the rear
end off too by pressing the OK button and selecting the
opposite side. Try it both ways—by the Retouch Menu and
the Playback Retouch Menu. Just remember that it’s a
two-step process.
Side-By-Side Comparison
(User’s Manual – D300S page 331; D300 page 342)
Side-by-side comparison allows you to compare an image
you’ve retouched with its original source image. Interestingly,
this function is not available on the Retouch Menu. You’ll
only find it on the Playback Retouch Menu.
Here are the screens and steps to compare the original and
retouched image side by side on the camera’s Monitor (see
Figure 6-27):
563
To Next Page
Loading...
