Nikon NPL-322 - Telescope and Measurement Performance

5 Menu Key
136 Total Station NPL-322 Instruction Manual
Uploading a point name list or code list
To upload a point name list via cable, press [3] or select PT List in the
Communication menu.
To upload a code list, press
[4] or select Code List.
Connect the RS-232C cable.
Start a terminal program on the computer.
To put the instrument into receive mode, press
[ENT] or
the
OK softkey.
The counter is updated as each line in the list is stored.
You can store up to 254 codes or point names.
1sec-Keys
Use the 1sec-Keys menu to configure the settings for
the one-second keys,
[MSR], [DSP], [USR], [S-O], and [DAT]. To
access this menu, press
[6] or select 1sec-Keys in the
MENU screen.
[MSR] key settings
To change settings for the [MSR1] and [MSR2] keys, press
[1] or select [MSR] in the 1sec-Keys menu.
When you upload a code list, it always replaces the existing code list on the instrument.
If a code or point name is longer than 16 characters, it is truncated.