Removing, Installing, and Replacing NICs
IP390 Security Platform Installation Guide 53
If you are installing or replacing a NIC, insert the NIC.
a. Insert the NIC bezel into the front panel.
b. Gently push the back of the NIC (as close as possible to the connector locations) down
toward the chassis tray assembly.
For T1 NICs, note that only two connectors on the NIC are used for the interface, as the
following figure shows.
Make sure that the NIC edge is completely seated into the connectors on the chassis tray
assembly.
00532a
00689
As shown on the
bottom of the T1 NIC,
only these two NIC
connectors are used
for the interface
To Next Page
Loading...
