Safety
1-10
Part 1089210A04
E 2010 Nordson Corporation
Moving and Storage
Moving or storing of the Nordson UV curing system must comply with all
applicable local and state regulations. All electrical power and other
services must be disconnected and the lamphead must be cool before
moving or storing this equipment. Power supplies should be properly
attached or fastened to an appropriate fixture such as a pallet for handling
and storing.
Due to the power supply’s weight, it is recommended a mechanical device
be used for handling and they should be kept as low to the floor as possible.
It is recommended that the bulb be removed from the lamphead and stored
or shipped in the original shipping tube. The lamphead and power supply
should be shipped and or stored in the original container or an equivalent
and kept dry and clean at all times.
Shipping of Nordson UV curing systems and their component parts must be
done in accordance with all applicable shipping regulations including
requirements for shipping of magnetic materials and mercury lamps.
Safety Symbols
The following safety symbols are used in this manual. The symbols are
used along with warnings to help you operate and maintain your equipment
safely. Pay attention to all warnings and follow directions to avoid personal
injury.
WARNING: Mechanical or combined mechanical/electrical hazards.
WARNING: Electrical hazard.
WARNING: UV/Microwave radiation hazard.
WARNING: Hot surface hazard.
CAUTION: Equipment hazard.
To Next Page
Loading...