Nordson CoolWave 2 - Light Detector Board Replacement

Maintenance
5-12
Part 1089210A04
E 2010 Nordson Corporation
Preparation (contd)
5. See Figure 5-14. Pull the the transformer and connector bracket from
the lamphead base.
Figure 5-14 Transformer and Connector Bracket
Light Detector Board
1. Follow steps 1−5 under Preparation.
2. See Figure 5-15. Disconnect the light detector board.
3. Remove the three screws and the light detector board.
4. Install and connect the new board.
5. Install the transformer and connector bracket.
6. Install the cover on the lamphead base.
7. Install the bulb and RF screen, if removed.
Figure 5-15 Light Detector Board Replacement