Installation
3-4
Part 1089210A04
E 2010 Nordson Corporation
Power Connections (contd)
Refer to Table 8-2. Current ratings indicate current demand during normal
full-power operation. Size supply wiring and circuit breakers or fuses to
allow for heavy current draw during startup.
To connect the power cord, remove the voltage cover on the back of the
power supply unit. Connect the power cord to the terminals labeled A, B, C,
and Ground.
Power Supply Balancing
If you are supplying power to more than one CW2 power supply from a
single source, connect the power lines as shown in Figure 3-3 to balance
out the load. If you have more than three power supplies, repeat the
sequence again starting with the fourth power supply. Refer to Table 8-2.
To Next Page
Loading...