Installation
3-1
Part 1089210A04
E 2010 Nordson Corporation
Section 3
Installation
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Introduction
This section contains information for installing the CoolWave 2 10-inch
lamphead and power supply. Directions for mounting and shielding are
explained in general terms due to differences for each independent
installation.
Inspection and Packaging
The Nordson CoolWave system has been carefully tested, inspected, and
packaged prior to shipping. Upon receipt, inspect the shipping materials
and components for visible damage. Report any damage immediately to
the shipper and to your Nordson representative.
NOTE: When opening the packaging, please take care so that the
packaging can be re-used to ship the unit to the next destination. Keep all
packaging materials together and in a location that they will not get
damaged.
Power Supply Installation
Mounting Guidelines
WARNING: Heavy equipment. Be careful when moving the power supply.
Use approved lifting equipment or get help. Failure to observe this warning
could result in personal injury or equipment damage.
See Figure 3-1.
S The power supply can be mounted on any horizontal surface.
S Install the power supply so the operator panel and disconnect switch are
easily accessible.
S The blowers mounted on the front and the rear of the power supply and
the exhaust vents on the sides must not be obstructed.
To Next Page
Loading...