Nordson iControl - Page 104

Parts
6-6
Part 1105779-04
E 2014 Nordson Corporation
Console Parts (contd)
See Figure 6-3 for the parts listed in this table:
Item Part Description Quantity Note
16 1100090 CONTROL UNIT, PC, panel mount, w/Ethernet 1 D
65 1051544
S INTERFACE CARD, PC104 CAN
1 B
66 1105343
S CARD, I/O, PC104
1 B
67 1076186 CARD, PCI Ethernet, iControl, Prodigy 1
17 1000594 SWITCH, keylock, 3 position 1
18 1000595 CONTACT block, 1-N.O. and 1-N.C. contact 2
19 1036690 PANEL, keypad, iControl 1
20 1100775 MODULE, 24 channel opto-isolated digital input 1 E
21 1032390 JUMPER, comb type, 6 pole, 10 mm AR A, C
63 −−−−−−
S CABLE, IDE, 80 conductor
1
23 1034281 MEMORY, CompactFlash 1
24 1034283 MEMORY, programmed, iControl 1
25 240674 TAG, ground AR C
26 983401 WASHER, lock, split, M5, steel, zinc AR C
27 984702 NUT, hex, M5, brass AR C
28 288806 CONTACT BLOCK, 2 N.O. contacts 1
29 334806 SWITCH, round, 2 position, 90 degree 1
63 1051542 CABLE, IDE, 80-conductor 1
NS 1055881 CABLE, CAT5 Ethernet, T568B colors, 30 ft 1
NOTE A: Jumpers may need to be trimmed to fit into the terminals.
B: Included with control unit.
C: Quantities of noted parts depends on system configuration and console type.
D: See Figure 6-2. When replacing an obsoleted PC with a new PC, order kit 1107109. When replacing a
new new PC, order 1100090 for a direct replacement. (Refer to the Repair section for PC replacement.)
E: When replacing an obsoleted module (Ax754), order kit 1107140. When replacing a new module
(PCLD-782B), order 1100775 for a direct replacement.
AR: As Required
Continued...
Obsolete PC New PC
Figure 6-2 Obsolete and New iControl PC