Using the Menus
5-38
Part 1124631_01
E 2015 Nordson Corporation
System Setup Screens (contd)
Item Menus Action
Compensation,
contd.
Recommended settings:
1 Set both compensation values
to zero.
2 Apply an adhesive pattern at a
very low speed.
3 Apply an adhesive pattern at
the highest normal run speed.
4 Measure the shift in the leading
and trailing edge of the bead.
5 Convert the pattern shift to time
(ms):
Metric:
Edge shift (mm)*60 = Compensation (ms)
Line Speed (m/min)
English:
Edge shift in. = Compensation (ms)
Line Speed (ft/min) *500
To Next Page
Loading...
