Using the Menus
5-37
Part 1124631_01
E 2015 Nordson Corporation
ActionMenusItem
Compensation
a
b
c
d
Compensation values are set
automatically based on your
applicator selection. The default
values can be changed when
necessary.
Compensation adjusts for any
shift in patterns as the line speed
changes from low to high. This
shift is caused by the mechanical
delays in the applicator. There is
a separate setting for on-delay
(see step b) and off-delay (see
step c).
S If the patterns shift
backward as the line
speeds up, a larger
compensation is needed
S If the pattern shifts forward
as the line speeds up, a
lower compensation value
is needed.
S If the pattern shifts in the
leading edge (on-delay), it
can be adjusted
independently of the trailing
edge (off-delay) of the
pattern.
aHoldtheApplicator button
on the Components screen to
access the Compensation menu.
b Tap numeric keypad to enter the
leading edge compensation.
c Tap numeric keypad to enter the
trailing edge compensation.
d Tap to reset the compensation to
the factory default setting.
Continued...
To Next Page
Loading...
