Using the Menus
5-36
Part 1124631_01
E 2015 Nordson Corporation
System Setup Screens (contd)
Item Menus Action
Components
4
a
b
c
The components screen is used to
set up the pattern controller with only
the applicator channels and triggers
that are being used in your
application.
Only the components that are
installed on this screen will show up
in other menus and screens.
aTaptheComponents button on
the System Settings screen.
b Tap the box or down arrow to
access list of applicator families.
From the list, pick the type of
applicator installed on your line.
NOTE: By default, applicators
are set to 0 – none. When an
applicator type is selected the
icon will be activated, indicated
by a green circle around the icon.
c Tap the trigger icons to activate
each installed trigger.
NOTE: A check mark indicates
that the syste m has automatically
detected the presence of a
photocell on the trigger input.
Trigger inputs can be manually
activated even if the system does
not detect a photocell.
Continued...
To Next Page
Loading...
