Integrator's Guide30
© 2017 Nortek AS
5.12 GETMEM
Returns the amount of memory that will be stored on the recorder for the burst and average data
as well as the combined plan value. Alternate mode values is also supported
Combined burst and average memory [Mbytes/hour]
Burst memory [Mbytes/hour]
Average memory [Mbytes/hour]
Combined burst1 and average1 memory [Mbytes/hour]
Alternate burst1 memory [Mbytes/hour]
Alternate average1 memory [Mbytes/hour]
Total memory value [Mbytes/hour]
5.13 SETTRIG/GETTRIG/GETTRIGLIM
Sets / gets the parameters and limits for Trigger. The available trigger types will depend on the
harness/cable used with the instrument.
When triggered the instrument will perform a complete ping (Tx and Rx) before it goes back to
monitoring the trigger. Any triggers asserted during an ongoing ping will be ignored. There are no
specific requirements for pulse length. The unit triggers on the edge(s) of the trigger signal and
can be triggered on rising, falling or both edges.
Enable/disable trigger functionality
Note: TRIGOUTPUT=1 enables master trig output, RS485EDGE trigger must be used with this
option. This enables several instruments to be synchronized together through RS485 with one of
the instruments acting as master. Only continuous measurement configurations are supported in
this mode.
5.13.1 TRIG
Command used for trigging measurement when Trigger is enabled and trigger type equals
“COMMAND”.
To Next Page
Loading...
Need help?
General
