Nortek Signature Series - Telemetry Configuration Commands

Commands 43
© 2017 Nortek AS
5.37 SETTMAVG/GETTMAVG/GETTMAVGLIM
Set/get averaging mode telemetry settings and get the relevant argument limits.
Argument
Description
EN
Enable Averaging Mode Telemetry
CD
Cells Divisor
PD
Packets Divisor
AVG
Average Telemetry Data
TV
Store Velocity
TA
Store Amplitude
TC
Store Correlation
CY
Coordinate System
FO
Enable File Output
SO
Enable Serial Output
DF
Data format:
(See Chapter 4)
DISTILT
Disable tilt
TPG
Enable storage of Percentage Good Data
The actual valid range for the various parameters for the firmware version is used can be found by
using the GETTMAVGLIM command. This command has the same arguments as the SETTMAVG/
GETTMAVG commands shown in the list above. The output format for limits is described in Data
Limit Formats.