Nortek Signature Series User Manual

Commands 39
© 2017 Nortek AS
5.31 GETSTATE
Returns information about the current operational state of the instrument
Argument
Description
MODE
Current instrument state
0001 – Measurement (START command received)
0002 – Command
0003 – Deploy (DEPLOY command received and deployment running)
0004 – Data retrieval
0005 – Confirmation
0006 – Network FTP
0008 – Pre-deployment (DEPLOY command received, but deployment has not
yet started)
0009 –Confirmation (measurement)
0010 – Confirmation (deploy)
0011 – Confirmation (pre-deploy)
0012 – Data retrieval (internal processing in progress)
DEPTIME
0 – DEPLOY command has not been received.
< 0 – Number of seconds until deployment starts.
> 0 – Number of seconds that deployment has been running.
MEASTIME
0 – START command has not been received.
> 0 – Number of seconds that measurement has been running.
CURRTIME
The current instrument time
Time format is “YYYY-MM-DD HH:MM:SS”
WAKEUP
Reason for instrument wakeup
0 – Bad power
1 – Power on
2 – Break
3 – Real-time clock
INTPROC
Internal processing Active

Nortek Signature Series Specifications

General

Type	Acoustic Doppler Current Profiler (ADCP)
Operating Temperature	-5°C to +45°C
Storage Temperature	-20°C to +60°C
Temperature Sensor	Integrated
Pressure Sensor	Integrated
Compass and Tilt Sensor	Integrated
Data Storage	Internal memory
Communication Interfaces	Ethernet, RS-232
Depth Rating	Up to 6000 meters (depending on model)
Data Output	ASCII, binary
Beam Angle	Varies by model
Velocity Accuracy	±0.5% of measured velocity ±1 mm/s