Voice Alarm Modules
9RLFH $ODUP 6\VWHP
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 4-19
&RQQHFWLQJ'XDO&KDQQHO0RGXOH&LUFXLWV
:LULQJ 1RWHV
• All speaker circuits are supervised and power-limited.
• Twisted-pair cable should be used for speaker circuit wiring.
• Maximum speaker circuit wire resistance is dependent upon wattage required at
each speaker.
• Refer to Table 4-14 for resistor values.
• Use only UL-listed speakers rated for 25 Vrms.
Table 4-14 DCM-4 Resistor Requirements
:LULQJ 'LDJUDP
Figure 4-20 shows typical wiring for CMX connections to speaker circuits:
)LJXUH 7\SLFDO :LULQJ IRU '&0 6SHDNHU &LUFXLWV 1)3$ 6W\OH <
For ELR connection to devices... Use resistor part number...
with terminals 71252
with flying leads 71245
used in Canada also include N-ELR Resistor Plate.
'&0 6SHDNHU &LUFXLWV
SRVLWLRQV DQG
1)3$ 6W\OH <
. ZDWW (/5
31 7DEOH
6SHDNHU &KDQQHOV $ DQG %
(QG HDFK XQXVHG
FLUFXLW ZLWK D . (/5
31
6SHDNHUV
1)3$ 6W \OH =
6SHDNHUV
'&0
1RWH )RU V\VWHPV ZLWK $$ DPSOLILHUV \RX FDQ
XVH 9UPV VSHDNHUV $OVR XVH . : (/5V
ZLWK 9UPV VSHDNHUV
www.PDF-Zoo.com
To Next Page
Loading...
