Notifier AFP-400 - Page 127

Wiring Speaker Circuits  9RLFH $ODUP 6\VWHP
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 4-27
:DWW)RXUDQG(LJKW6SHDNHU&LUFXLWV
:LULQJ 1RWHV
When wiring four-and eight-speaker circuits using 30 watts of power, note the
following:
1. An AA-30 supplies audio power through plug P6, or terminals 5 and 6 on terminal
block P8. This audio power run is not supervised. If using the optional supervised
return, a loss of audio power (due to a break in the wiring) generates a trouble
signal at the AA-30.
2. If using an optional supervised four-wire return, cut resistors R8 and R9, located
directly under plug P6 on the AA-30.
3. Each speaker circuit can share a maximum of 30 watts.
:LULQJ )RXU 6SHDNHUV
Figure 4-31 shows typical wiring for wiring four speaker circuits using 30 watts of
power:
)LJXUH  7\SLFDO  :DWW )RXU6SHDNHU &LUFXLW
:LULQJ (LJKW 6SHDNHUV
Figure 4-32 shows typical wiring for wiring eight speaker circuits using 30 watts of
power:
)LJXUH  7\SLFDO  :DWW (LJKW6SHDNHU &LUFXLW
2SWLRQDO VXSHUYLVHG
5HWXUQ QRWH 
 ZDWWV ² 7KHVH IRXU FLUFXLWV
VKDUH  ZDWWV
3 3
 ZDWWV ² 7KHVH HLJKW FLUFXLWV
VKDUH  ZDWWV
2SWLRQDO VXSHUYLVHG
5HWXUQ 1RWH 33
www.PDF-Zoo.com