Notifier IFS-2600 User Manual

IFS-2600 Fire Indicator Panel Section 5
Programming
DOC-01-009 36
Section 5 - Programming
5.1. Program Mode
Press the following buttons in order shown to enter programming mode.
PREVIOUS
→
NEXT
→
SELECT
→
EXIT
→
ENTER
Programming Mode
The liquid crystal display will display all messages and prompts required to program the IFS-2600 Panel.
Only the "PREVIOUS","NEXT","SELECT","EXIT" AND "ENTER" keys are used in programming mode. All
other keys will give an error beep and should be ignored.
Alarm detection is not affected during the programming function but you must exit programming mode if
any other panel functions are to be performed including acknowledge and reset of alarms.
EXIT
SAVE CHANGES
YES NO
Programming Hierarchy
ZONES RELAY
GLOBAL PRINT
Zones
TYPE
OUTPUT
STD LATCHING INDICATE
STANDARD LATCHING AVF I BELL
NON LATCH IB GENERAL
NON LATCH 20S IBG ACF OUT
TIME DELAY 10S IBGA BRIGADE 1
TIME DELAY 20S IBGA BRIGADE 2
TIME DELAY 30S IBGA BRIGADE 1 & 2
TIME DELAY 40S
TIME DELAY 50S
TIME DELAY 60S
NOTE:
Refer to appendices for detailed explanation of functions.

Notifier IFS-2600 Specifications

General

Brand	Notifier
Model	IFS-2600
Category	Fire Alarms
Language	English