PN7462 family Quick Start Guide - Development Kit
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
(2) ATB response 0x50AEF9ACD3058901013381E1 with TX_IRQ as trigger.
Fig 45. AWG setup for type B @ 106
The amplitude defines the peak voltage level of the LMA: the LMA output toggles
between 0V and the defined amplitude. The AWG output can directly drive a Reference
PICC modulation input.
Note: EMVCo LMA levels normally are in the range of 700 … 800 mV for minimum LMA
test in operating Volume 1. For compliance test it is recommended to use a calibrated
reference tool like e.g. the CTC Advanced WavePlayer.
The PICC response itself can be defined as hexadecimal data. The Fig 45 shows the
example of a ATQB (0x50AEF9ACD3058901013381E1), which does not yet contain a
CRC, but SOF and EOF.
<Add CRC> adds the CRC to the given string (0xE012).
To Next Page
Loading...
