Nytech DS-8210 User Manual

Nytech DS-8210 Introduction
English - 9
Inserting the Battery
When the battery is fully charged, insert it into the Nytech DS-8210 as
shown below.
- Open the Nytech DS-8210 battery compartment by pushing the cover
gently outwards. The cover will spring up by a spring mechanism.
- Move the unlock button (see the figure below) to the side and then place
the rechargeable battery with the marking orientated towards the camera
front panel into the battery compartment. Insert the battery fully into the
housing. The rechargeable battery should be inserted gently and without
offering resistance.
- Close the battery compartment cover by pressing down the flap on the
housing of the camera and then by pushing it inwards till it locks. The
cover clicks into place.
To remove the rechargeable battery push the unlock button outwards. The
rechargeable battery will protrude a little so that you can get a hold of it and
remove it.
When the rechargeable battery is empty the status indicator [2]
will light red and the message Replace battery appears on the
display [12]. Make sure that the camera is switched off before
you remove the rechargeable battery.
Unlock button
i

Nytech DS-8210 Specifications

General

Brand	Nytech
Model	DS-8210
Category	Digital Camera
Language	English