Nytech DS-8210 Introduction
English - 11
Write-Protecting the Memory Card
The supplied memory card features a write-protection tab. When the write-
protection is enabled (see the figure below) you will be able to view any
existing pictures only, but not be able to delete or edit them. Also, it will not
be possible to record any new pictures onto the memory card.
Write protection disabled Write protection enabled
If you attempt to take a picture while the write protection is
enabled, when pressing the shutter button [3] the message Card
locked will appear on the display [12].
Switching the Camera On and Off
Press the Power button [1] and keep it pressed down for approximately 1
second to turn it on in Recording mode. Or you can press the Play button
[5] and keep it pressed down for approximately 1 second to turn the
camera on in Playback mode.
Press the Power [1] button to switch off the camera.
Power-Saving Function
The Nytech DS-8210 is equipped with an automatic power-saving function
to extend the rechargeable battery life. By default, the LCD display [12]
powers off after one minute if the camera is not being used. Press any
button to power on once again the LCD display.
You can alter the preset timeout for the energy-saving function. To do this,
read page 53 – Power-Saving Function.
i