5-8 Print Controller User’s Guide
Chapter 5 Scanner Operation
[SCAN DENSITY]
Press this key to select a read density. The default is the same as that in the copy
mode.
When the original document is being read, you can change the density, but you cannot
select [AUTO] in the process.
[LENS MODE]
Press this key to change the magnification ratio at which the original document is read.
You can select [ZOOM], [RE] or [1:1]. [RE] is the same as the default in the copy mode.
[ZOOM] range in each resolution are as follows:
200 dpi: 0.66 - 4.00
300 dpi: 0.44 - 4.00
400 dpi: 0.33 - 4.00
600 dpi: 0.33 - 2.00
[SCAN SIZE]
Press this key to select the scanning paper size.
Available only when using the Platen mode. You can select [AUTO] or [SIZE SETTING].
[AUTO]: Same as the default in the copy mode
[SIZE SETTING]: Allows you to select a scanning frame size.
Example: When an 5.5”x8.5” original is loaded and you select 8.5”x11”,
then the scanning takes on the 8.5”x11” frame.
Options: 5.5”x8.5”, 5.5”x8.5”R, 8.5”x11”, 8.5”x11”R, 8.5”x14”, 11”x17”,
A3, A4R, A4, A5R, A5, A6R, B4, B5R, B5, B6R, F4, Full AREA
Default is [AUTO].
To Next Page
Loading...