Oce TDS320 - Page 24

24 Océ TDS320 User Manual
▼ Set the media width settings
1 Press the On-line key to put the printer off-line.
2 Select the ‘Media settings’ item with the or key.
3 Press Next/select to enter the ‘Media settings’ menu.
4 Select ‘Roll 1’or ‘Roll 2’ with the or key.
5 Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6 Select the ‘Width’ item with the or key.
7 Press Next/select to enter the ‘Width’ menu.
8 Select the desired width with the or key.
9 Press Next/select to confirm the selected width.
10 Press On-line to put the printer on-line again.
▼ Set the media type settings
1 Press the On-line key to put the printer off-line.
2 Select the ‘Media settings’ item with the or key.
3 Press Next/select to enter the ‘Media settings’ menu.
4 Select ‘Roll 1’, ‘Roll 2’, ‘Manual feed’ with the or key.
5 Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6 Select the ‘Material’ item with the or key.
7 Press Next/select to enter the ‘Material’ menu.
8 Select the desired media material with the or key.
9 Press Next/select to confirm the selected media material.
10 Press On-line to put the printer on-line again.