Use the Océ TDS320 to print 29
Configuration
Select a language
On the operator panel of the Océ TDS320 Printer you can indicate which
language you use to display the printer information, like status and error
messages.
▼ Select a language
1 Press the On-line key to put the printer off-line.
2 Select the ‘Configuration’ item with the or key.
3 Press Next/select to enter the ‘Configuration’ menu.
4 Select ‘Language’ with the or key.
5 Press Next/select to enter the ‘Language’ menu.
6 Select the desired language with the or key.
7 Press Next/select to confirm the selected language.
8 Press On-line to put the printer on-line again.
9 Turn the printer ‘off’ and ‘on’ again.
Network settings
The Océ TDS320 has 2 network adapters. To set the network settings you must
enter the network data in 4 fields.
■ Use DHCP server. The Dynamic Host Configuration Protocol (DHCP) is a
protocol to a u tom a te the a ssig nment of Internet Protocol ( IP) addresses in a
netw ork . W ithou t DHCP, th e IP address m u st be entered m a nu a lly .
■ IP address. An IP address has two parts: one part identifies the network (with
the network number) and the other part identifies the specific machine or host
within the network (with the host number).
■ Subnetmask. A subnet (short for ‘subnet work’) is an identifiably separate
part of an organization's network. To manage routing that could and should
be handled within an organization.
■ Set default gateway A g a tew ay is a netw ork point tha t a cts a s a n entra nce to
another netw ork .
Enter the following ‘password’ (key sequence) to get access to the System
menu on the printer to set the network settings.
To Next Page
Loading...
