Oce TDS320 - Start Océ Remote Logic on your system; Command line parameters

90 Océ TDS320 User Manual
Start Océ Remote Logic
®
on your system
▼ Start Océ Remote Logic
®
1 Select 'Océ Remote Logic' via the 'Start' menu.
2 Select ' Application Launcher'.
3 Select the Océ Settings Editor from the ‘Application Launcher’.
Command line parameters
In order to start Océ Remote Logic
®
faster, there are 6 command line
parameters available.
configfile=<config_file> Sets the configuration file to use.
server=server Sets the specified server as the server to connect to.
language1=lang Specifies the first language in combination with the
parameter ‘country1=country’
.
country1=country Specifies the first language in combination with the
parameter ‘language1=language
’.
language2=lang Specifies the second language in combination with the
parameter ‘country2=country’
.
country2=country Specifies the second language in combination with the
parameter ‘language2=language
’.
Note: You must always use a matching combination of ‘lang’ and ‘country’
(see table on page 91).