37
TO SET - PC SAMPLING RATE
(while in the Surface Mode)
Factory set for 30 (seconds), the Sampling Rate can be set to
values of 2, 15, 30, or 60 seconds, or 2, 5, or 10 feet (.5,
1.5, or 3 meters).
• Press Both buttons simultaneously, release when SET: 2
appears.
• Press and release the Advance (Front) button, the Units
screen appears with the set point flashing.
• Press the Advance (Front) button 13 more times.
• The graphics SR and SECS appear with the Sampling
Rate value flashing (Fig. 37).
• Press and release the Select (Side) button to advance the
Rate one selection at a time, or press and hold the button to
scroll through the Set Points.
• Press the Advance (Front) button to accept the setting and
advance to Set Digital Gauge Mode, or press and hold
Both buttons for 2 seconds to revert to Surface Mode.
Fig. 37 - Set Sampling Rate
NOTE:
Sampling Rate is the
interval at which data
samples are recorded
during a dive for
subsequent
download to the PC
program. This
setting has no effect
on displayed data or
data in the unit's
viewable Log.
To Next Page
Loading...
