39
TO SET - WATER ACTIVATION
(while in the Surface Mode)
Factory set for ON, the Water Activation feature can also be
set for OFF (disabled) to prevent inadvertent activation during
travel or storage. When set ON, the Versa Pro will automati-
cally Activate and enter Dive Mode upon immersion in water.
• Press Both buttons simultaneously, release when SET: 2
appears.
• Press and release the Advance (Front) button, the Units
screen appears with the set point flashing.
• Press the Advance (Front) button 15 more times
(14 more times after a dive in Digital Gauge Mode).
• The graphics ACT and H20 appear with ON (or OFF)
flashing (Fig. 39).
• Press and release the Select (Side) button to toggle be-
tween ON and OFF.
• Press the Advance (Front) button to accept the setting and
revert to Surface Mode.
Fig. 39 - Set Water Activation
WARNING: If
this feature is
set for OFF, the
Versa Pro must
be manually
activated prior
to commencing
a dive.
To Next Page
Loading...
