Oki Data CONFIDENTIAL
42930511TH Rev. 2 28 /
2.4.1 Electrophotographic Processing Mechanism
(1) Electrophotographic process
The overview of the electrophotographic process is described below.
1 Electrification
DC power is applied to the CH roller to evenly negatively electrify the surface of the
OPC drum.
2 Exposure
The LED head irradiates light on the surface of the OPC drum that is charged with
a negative electrical load. The negative electrical load attenuates according to the
intensity of light, for the irradiation area of the OPC drum surface. Further, the
electrostatic latent image is created on the OPC drum surface according to the
electrical potential.
3 Development
The negatively charged toner comes in contact with the OPC drum to fuse the
electrostatic latent image by electrostatic force, to create a significant image on the
surface of the OPC drum.
4 Transfer
Paper is pressed against the surface of the OPC drum, then conveyed by the transfer
roller from behind. The toner and positive electrical load of a reverse electrode is
applied, then the toner image is transferred to the paper.
5 Cleaning
The cleaning blade removes residual toner on the OPC drum after the toner is
transferred to the paper.
6 Fuser
Heat and pressure is applied to the toner image on the paper to fuse the image on
the paper.
To Next Page
Loading...
Need help?
General
