Oki Data CONFIDENTIAL
42930511TH Rev. 2 158 /
When Replacing HMO PCB
or
When Replacing OkiLAN 8200e (HMK PCB)
5.2.5 Restoring Flash ROM Details of the CU PCB (600dpi Model)
The CU PCB is mounted with 4MB of Flash ROM. This allows the user to register voluntary files.
When replacing the CU PCB, print the file list of the information menu before replacement.
Then check the files that are already registered.
What’s more, after replacement, always re-register the files necessary.
5.2.6 Precautions When Replacing OkiLAN 8200e or OkiLAN 8200e Mounted CU PCB (600dpi Model)
When Replacing OkiLAN 8200e (Soft NIC HMK PCB) or OkiLAN 8200e Mounted CU PCB (HMO PCB),
or when replacing CU (HMO PCB) and OkiLAN 8200e at the same time, there is a need to initialize
the network information stored on the Flash ROM.
• When it is necessary to initialize the network information (600dpi Model)
Note
[How to Initialize the Network Information] (600dpi Model only)
(1) Turn OFF the printer.
(2) If the network cable is connected to the printer, disconnect the cable from the printer-side.
(3) Press the black push switch ([Test] Button) on the OkiLAN 8200e, and turn on the print.
Continue to press the black push SW until the following message appears on the top row
of the operation panel “One Moment” or the following message appears on the bottom
row “Initializing network”.
There is no longer any need to press the black push SW once the above is displayed.
(4) Initialization is completed if “Ready to Print” appears on the operation panel.
For 1200dpi, OkiLAN 6500e
[Procedure to Check that Network Information Has been Initialized]
(1) Printer the “Printer Information” and “Setting Details”.
(2) Check the following 2 points in the “Network” area of the first sheet of the results printed
for the setting details.
Slot: 100/10 Base
MAC Address
Short Printer Nam
IF the number value is the same (3 bytes), the network information has been success-
fully initialized.
Note
OkiLAN8200e
HMO PCB
To Next Page
Loading...
Need help?
General
