Changing settings from the operator panel
- 108 -
Item
Factory
default
Description
Auto Power Off Time (Fn202) 4hours Sets the time that will elapse before the
power is turned off automatically after the
standby mode is entered.
Value range: 1 hour, 2 hours, 3 hours, 4
hours, 8 hours, 12 hours, 18 hours, 24 hours
Silent Mode On Specifies the printing preparations when the
standby mode is switched from the sleep
mode.
[On]: Silent due to no preparation for
printing.
[Off]: The image drum makes a noise as it
prepares for printing, facilitating a faster
speed for the first printing start time.
Clearable Warning ONLINE
Sets the timing to clear the recoverable error
display.
Auto Continue Off Sets whether or not to automatically restore
this machine when a memory overflow or
Manual Timeout 60 seconds Sets the waiting time for loading the paper
when you print with [Feed paper individually]
checked in the printer driver.
Value range: Off, 30 seconds, 60 seconds
Timeout Injob 40 seconds Sets the time from loss of the data receipt
(canceled by PostScript Emulation) until
force-printing.
Value range: Off, 5 seconds, 10 seconds, 20
seconds, 30 seconds, 40 seconds, 50
seconds, 60 seconds, 90 seconds, 120
seconds, 150 seconds, 180 seconds, 210
seconds, 240 seconds, 270 seconds, 300
Timeout Local 40 seconds Sets the time to keep each port open after
printing. (Except for network)
The value range is from 0 to 300 seconds in
Timeout Network 90 seconds Sets the time to keep the network port open
after printing.
The value range is from 0 to 300 seconds in
Low Toner Continue Sets the action of this machine when [Toner
Low] is displayed.
This machine goes offline when [Stop] is
Print Mode w/o Color Toner Alarm Specifies the action when there is an empty
color toner cartridge.
[Alarm]: This machine stops without printing
the color print data.
Replace the empty toner cartridge with a
new one.
[Cancel]: Cancels color print data
automatically.
Replace the empty toner cartridge with a
To Next Page
Loading...
